Check Point 61000 Manuel de service télécharger pdf (Page 21)

Inserting Chassis Management Modules

Step 3: Installing Components and Connecting Power Cables Page 21

Inserting Chassis Management Modules

To insert a Chassis Management Module:

1. Open the latch at the top

2. Insert the Chassis Management Module into the allocated slot.

Note - If you have only one CMM, we recommend inserting it into the lower chassis slot

3. Fasten the latch.

4. Close the two tumble screws tightly.

5. After power up, all LEDs must light up for 1-2 seconds. The ACT and PWR LEDs continue to show

green after the other LEDs turn off.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 46 47

Pas de commentaire

Check Point 61000 Manuel de service Page 21