Check Point 4000 Manuel de service télécharger pdf (Page 33)

Check Point 4000 Appliances Hardware

Check Point 4000 Appliances Getting Started Guide | 33

When Entering an IP Address

Press

Enter the grub menu

Move to the next digit

Move back to the previous digit

Approve the change

when the cursor is located on the last digit

Cancel the IP change

when the cursor is located on the first digit

Change current digit

Configuring Management DHCP

You can use the LCD panel to enable or disable DHCP on the management interface.

To configure management DHCP using the LCD panel:

1. Press Enter .

The panel shows Select > Network.

2. Press Enter .

The panel shows Network > DHCP.

3. Press Enter .

The panel shows that DHCP is enabled or disabled.

4. Press Up .

 If DHCP was disabled - DHCP is enabled on the management interface.

 If DHCP was enabled - DHCP is disabled on the management interface.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 48 49

Pas de commentaire

Check Point 4000 Manuel de service Page 33